OLD TABOR RAIDR INSTRUCTIONS

 

Base set.

Activate CC to get the steps in text in the video.

IMPORTANT! DO NOT USE POWERTOOLS!

*NOTE FOR INDEX USERS
Current design can at some cases scratch your controllers
depending on playstyle, till next revision, we recommend adding tape, preferably electric tape, on the metal rod that's facing the controller.

  1. This is how you'll receive Tabor Raidr.
    Fetch your Phillips screwdriver (preferably PH2 head).
  2. Let's start with back controller.
    Put the rubber holder to the side. Loosen the lever.
  3. Rotate into position, clamp down the lever.
  4. With lever in locked position, tighten clamp screw till it feels solid.
  5. Still in lever lock, tighten brick screw till it feels solid.
  6. Unlock the lever and tilt backwards,
    clamp the lever and tighten pole screw till if feels solid.
    During first few weeks, this might need to be done once in a while
    if you experience slippage, this is normal.

  7. Time to reseat the rubber holder. Note direction.
  8. Count the holes from the beginning of the strap to determine
    what size your controller needs.
    Do not overtighten the strap,
    you will gain very little and risk scratching
    the controller     and damage the strap.

    Don't forget inserting the end of the strap into the slot, this will keep your controller from scratching against the metal rod.

    Reference:
  9. Some controllers with closed loop tracking will need
    a different approach for tightening (currently Index, PSVR2 & Pico4).
    Do not overtighten the strap,
    you will gain very little and risk scratching
    the controller     and damage the strap.

    Don't forget inserting the end of the strap into the slot, this will keep your controller from scratching against the metal rod.
  10. Redo the procedure for front controller.
  11. Adjust controller positions to your liking by
    releasing the lever and tightening it when satisfied.
    In game, adjust the controllers to fit the gun your using.

 

Butt stock upgrade.

 

Apto upgrade.
Coming soon.


Q&A

* What's this little bugger all about? 

This a temporary friend, a little glued hat with the mere purpose
to ease mount in packing. Keep until it leaves you by own will,
it serves no purpose design wise.

 

* The lever crawls back up in to open position no matter how hard I tighten...

This usually happens when the lever screw gets stuck in one of the two clamps. Open the lever fully and rattle it then try to tighten again.